It's Tuesday so you've got Kathi here to share a project with you! This week's focus is "Anything Goes". I'm continuing to experiment with Lindy's Gang's products and wanted to use my new Take Flight A& Clear Stamp Set TE9 by Tracy Evans Boutique.
Here's my card!
Cut a piece of Mixed Media cardstock in half, then in half again, which will leave you with four 4.5" x 6" panels.
Place one of the panels onto the center of a wooden cutting board. Tape all four sides of the panel to the cutting board with low-tack tape. This will help prevent the panel from warping and curling.
Use a water-filled Fine Spray Misters by Spectrum Noir to mist the panel until it's wet. Dip a dry paint brush into Clam Bake Beige Pigment Powder from the Nantucket Pearls Magical Pigment Powder Set by Lindy's Gang and tap the paint brush to sprinkle the pigment powder onto the wet panel. The powder crystals will begin to bloom and spread. Dip another dry paint brush into the Seagrass Green Pigment Powder from the Nantucket Pearls Magical Pigment Powder Setand tap the paint brush to sprinkle the pigment powder onto the wet panel. Use another dry paint brush and repeat the process with Whale Watch Blue Pigment Powder from the Nantucket Pearls Magical Pigment Powder Set.
Mist the panel with water and heat set. Take a look at the panel and repeat the above process until you're happy with the coverage and blending.
Spray the panel with Cactus Gold Glitz Spray from the Glitz Spritz Sprays Set by Lindy's Gang to add a touch of gold glitter. Thoroughly heat set the panel.
Remove the tape and move the panel onto the base of a stamping platform. Secure it with magnets and/or low-tack tape.
Position the focal stamp from the Take Flight A& Clear Stamp Set TE9 by Tracy Evans Boutique in the center of the inked panel. Ink the stamp with Nocturne VersaFine Clair Ink by Imagine Crafts/Tsukineko and stamp. Re-ink and stamp again if necessary to attain a good impression. Remove the panel from the stamping platform and heat set.
My impression wasn't the best and I lost some detail likely because the surface was a bit uneven. I used a black pen to fix it as much as possible. Use a Sparkle Clear Overlay Brush Pens by Spectrum Noir to add glitter to the wings, then heat set the image panel.
Place the image panel back onto the stamping platform and secure it with magnets and/or low-tack tape. Position the "Take Flight" Sentiment Stamp from the Take Flight A& Clear Stamp Set TE9 facedown on the top right of the image panel. Ink the stamp with VersaMark and stamp. Ink the stamp with Nocturne VersaFine Clair Ink and stamp.
Remove the panel from the stamping platform, sprinkle clear detail embossing powder onto the wet ink, dump the excess back into its container, and heat set the embossing powder.
Trim the image panel to 3.25" x 4.75" and heavily edge it with Nocturne VersaFine Clair Ink. Adhere the image panel to a 3.5" x 5" black card.
Please pop over to my blog, Kat's Tales of Stamping, for step-by-step instructions and complete supply lists.
Topflight Stamps Products Used:
Thank. you for visiting today!
No comments:
Post a Comment